Drilling cutting boxes for sale

Drilling cutting boxes are a kind of tank to contain drilled solids in well drilling. Both for onshore and offshore o&g drilling.

Drilling cutting boxes introduction

The boxes are usually rectangular tanks. They can be configured on typical oilfield 3-leg mounted skid, can be common container shape, or the traditional roll off. They are always open top for convenient materials handling, furthermore, they are water tight type without leakage

Drilling cutting boxes

Drilling cuttings box is more and more popular now. Not only used on offshore rig, presently, the environmental conservation standard and requirements are much higher cutting box is a tool/device used in drilled waste management. It is the vessel/medium holding drilling cuttings and/or other waste to be processed

Drilling cuttings tank also refers to mud skips. Mud skips are used for transportation and safe handling of hydrocarbon contaminated drill cuttings to and from rig platforms (Mainly the offshore platforms). These units provide a safe and efficient means of containment of drilling waste for transport to treatment and disposal sites

Cutting tanks design

The cuttings tank, also referred to mud skips, certainly can be designed variously as the clients’ demand vary much. But the bottom and general dimensions are same. For example, the tanks can be designed with corrugated plate thicks 8mm. Another proposal is the tanks designed with wall thicks 6mm. And the height can be different. For example, we Aipu produce mainly 2 model drilling cutting box. One is 2200x1600x1060mm, another is 3500x1600x1650mm.

Furthermore, the cuttings tank door on top can be different with various sealing gasket and switch. Complete unit should be marine usage adaptable. For the lifting rings/holes, should be all certified and tested by qualified third party to get marine qualification. The bottom should be configured with fork hole for convenient loading or unloading.

For convenient transportation and piling up all tanks for one user should be completely same on dimension, specification, loading capacity, etc. We just got an potential order on about 100 drilling cutting boxes. This lot items will be used on offshore rig. All items in this order should be produced with same specs and standard.